User Manual Part 3

MAC Filtering Setup

4020210 Rev

145

5 In the Protocol Type field, select one of the following protocols from the drop-

down menu.

 PPPoE

 IPv4

 IPv6

 AppleTalk

 IPX

 NetBEUI

 IGMP

6 In the Destination MAC Address field, enter the frame's destination MAC

address.

7 In the Source MAC Address field, enter the frame's source MAC address.

8 In the Frame Direction field, select one of the following choices from the drop-

down menu:

 LAN<->WAN

 WAN<->LAN

9 Do you want to select all WAN interfaces?

 If yes, check the Select All WAN Interfaces check box under the WAN

Interfaces (Configured in Bridge mode only) field.

 If no, uncheck the Select All WAN Interfaces check box under the WAN

Interfaces (Configured in Bridge mode only) field.

10 Click Save/Apply to add the MAC Filter.

Forwarding or Blocking MAC Layer Frames

You can change the policy on how MAC layer frames are forwarded or blocked.

FORWARDED means that all MAC layer frames will be forwarded except those

matching with any of the specified rules in the table on the screen. BLOCKED means

that all MAC layer frames will be blocked except those matching with any of the

specified rules in the table on the screen.

To change the policy on how MAC layer frames are forwarded or blocked, complete

the following steps.

1 Click Security on the main screen. The Packet Filtering tab opens by default.