User Manual

WAN Quick Setup
4030765 Rev 01 99
Configuring the WAN Interface (MER Broadband Type)
To configure a WAN interface for MAC Encapsulation Routing (MER) broadband
type, complete the following steps.
1 Click Home Network on the main screen. The Client Summary screen opens.
2 Click WAN Setup. The WAN Quick Setup screen opens.
Q. to reviewers: Need to click Add or Edit to see this screen.
3 Click Add or Edit.
<Need populated screen screen>
4 In the Broadband Type field, enter DSL.
5 In the DSL Mode field, select ATM. More fields populate on the screen.
6 Complete the following fields on the screen as follows:
Note: This configuration is an example of a specific setting for the residential
gateway. Your values may differ depending upon your service provider.
a In the Broadband Connect Type field, select MAC Encapsulation Routing
(MER).
b In the Encapsulation Mode field, select LLC/SNAP - Bridging.
c Select the VLAN Mux - Enable Multiple Protocols Over a Single PVC check
box.
d In the VLAN ID[0-4095]: field, enter an ID for the VLAN. Values are 0-4095.
e In the VPI field, enter the virtual path identifier (VPI). Values are: 0 to 65535
f In the VCI field, enter the virtual channel identifier (VCI). Values are: 0 to
65535
g In the the Service Category field, select UBR Without PCR.
h Select the Enable Quality of Service check box.
i Select the Obtain an IP address automatically option.
j Select the Obtain default gateway automatically option.
k Select the Obtain DNS server addresses automatically option.
3-6-2009 Draft