User's Manual

2. DHCP is not supported over IpoA. Enter your WAN IP
address, WAN Subnet Mask, gateway IP address and DNS
server IP address provided by your ISP to configure the
WAN IP settings. Then click Next button.
3. The Network Address Translation Settings page will appear.
If you want to enable NAT function, check the box Enable
NAT. If NAT is enabled, it will display a NAT submenu on
the left panel after reboot.
NAT occurs when multiple IP addresses on a private LAN are
converted to one public address. This public address is sent out
to the Internet. NAT increases security because the IP address
for a PC connected to the private LAN is never transmitted to the
Internet. NAT also allows xDSL/cable routers to be used with
low-cost Internet accounts, where only one TCP/IP address is