User Manual
Table Of Contents
- Cisco Model DPH650 MoCA to Wireless Adapter User Guide
- IMPORTANT SAFETY INSTRUCTIONS
- FCC Compliance
- Introducing the DPH650
- What's in the Carton?
- Front Panel Description
- Back Panel Description
- System Requirements for the DPH650
- Where Is the Best Location for the DPH650?
- How Do I Mount the DPH650 on the Wall?
- Connecting the DPH650 for Wireless Networks
- Configure the DPH650
- Configure TCP/IP Settings for Your PC
- Having Difficulty?
- Tips for Improved Performance
- How Do I Renew the IP Address on My PC?
- Notices
- For Information
8 4027494 Rev A
FCC Compliance
This transmitter must not be co-located or operated in conjunction with any other
antenna or transmitter.
IMPORTANT NOTE: FCC and IC Radiation Exposure Statement:
This equipment complies with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The availability of some specific channels and/or operational frequency bands are
country dependent and are firmware programmed at the factory to match the
intended destination. The firmware setting is not accessible by the end user.
Industry Canada statement:
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired
operation.
This device has been designed to operate with an antenna having a maximum gain
of 5 dBi. Antenna having a higher gain is strictly prohibited per regulations of
Industry Canada. The required antenna impedance is 50 ohms.