User Manual
Table Of Contents
- Cisco Model DPH650 MoCA to Wireless Adapter User Guide
- IMPORTANT SAFETY INSTRUCTIONS
- FCC Compliance
- Introducing the DPH650
- What's in the Carton?
- Front Panel Description
- Back Panel Description
- System Requirements for the DPH650
- Where Is the Best Location for the DPH650?
- How Do I Mount the DPH650 on the Wall?
- Connecting the DPH650 for Wireless Networks
- Configure the DPH650
- Configure TCP/IP Settings for Your PC
- Having Difficulty?
- Tips for Improved Performance
- How Do I Renew the IP Address on My PC?
- Notices
- For Information
4027494 Rev A 17
How Do I Mount the DPH650 on the Wall?
Location and Dimensions of the Wall-Mounting Slots
The following illustration shows the location and dimensions of the wall-mounting
slots on the bottom of the DPH650. Use the information on this page as a guide for
mounting the DPH650 to the wall.
Wall Mounting Instructions
Complete these steps to mount the DPH650 to the wall.
1 Locate the place where you want to mount the DPH650 to the wall.
2 Hold the DPH650 level against the wall and at an angle so that the screw hole
mounting guides are facing up and against the wall.
3 Lay a pencil, pen, or other marking tool into each guide and mark the place on
the wall where you want to drill the mounting holes.
4 Using a drill with a 3/16-in bit, drill two holes at the same height and 4 inches
apart.