User Manual

BW1251 Nov 15, 2006
Browan Page 34 of 72
When BW1251 network interface uses DHCP to get IP address dynamically, DHCP
relay service cannot be enabled.
Network | NTP Settings
NTP (Network Time Protocol) is used to synchronize the system time with the selected network NTP
server. Use the Network| NTP Settings menu to configure the NTP service:
Figure 153 – NTP Settings
NTP Status – enabling or disabling NTP service.
Time Zone – specifying the time zone for NTP service.
Delete – deleting the existed NTP server.
Edit – editing the settings of the existing NTP server.
Add – adding a new NTP server setting to synchronize time.
Clicking the Add button to add a new NTP server:
Figure 164 – Add new NTP server setting
Two NTP servers can be configured under Network | NTP Settings menu. And
only IP address is accepted for NTP server.
It is required to add at least one NTP server before enabling NTP service.
The Name of NTP server should be unique.