User Manual

file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_upgrade.html
1. Use a networking cables to connect the access point directly to the computer. Do
not try to use a wireless connection for this procedure.
2. Locate the folder that contains the firmware file that you downloaded.
3. On the USRobotics Installation CD-ROM, locate the Manual_Upgrade.cmd utility.
4. Drag the firmware file onto the Manual_Upgrade.cmd utility icon and follow the
on-screen instructions.
5. Set IP addressing for the network adapter on the computer back to "Obtain an IP
address automatically" as follows:
A. Open the Control Panel and double-click Network Connections.
B. Right-click the Local Area Connection of the network adapter that
connects the computer to the networking device and select Properties.
C. On the General tab, select Internet Protocol (TCP/IP) and click
Properties.
D. Select Obtain an IP Address Automatically and click OK.
E. Click OK again.
file:///G|/CSO/Documentation/Documentation%20-%20Dra...ach-1%20AP/User%20Guide/English/trouble_upgrade.html (3 of 8)10/26/2006 9:47:15 AM