User Manual
Table Of Contents
- index.html
- features.html
- install.html
- config.html
- client_connect.html
- ses.html
- status.html
- security.html
- lan.html
- wireless.html
- device.html
- tut_ap.html
- tut_client.html
- tut_repeater.html
- tut_bridge.html
- troubleshooting.html
- trouble_cd.html
- trouble_client_comm.html
- trouble_client_comm_02.html
- trouble_client_scan.html
- trouble_locator.html
- trouble_ses_client.html
- trouble_unicast.html
- trouble_wui_access.html
- trouble_connect_speed.html
- trouble_wds.html
- trouble_power.html
- trouble_upgrade.html
- trouble_internet.html
- trouble_ping.html
- support.html
- faq.html
- regulatory.html
- copyright.html
- warranty.html
file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/trouble_upgrade.html
Wireless Nd1 Access Point:
User Guide
● Home
● Installation
● Configuration
● Tutorials
● Help
After I performed a firmware upgrade, the access point did not
display its status page.
Solution
The upgrade may still be in progress. Wait for at least two minutes.
Solution
If you received the upgrade completion message, reboot the access point by
disconnecting and then reconnecting its power supply.
Solution
file:///G|/CSO/Documentation/Documentation%20-%20Dra...ach-1%20AP/User%20Guide/English/trouble_upgrade.html (1 of 8)10/26/2006 9:47:15 AM