User Manual

file:///G|/CSO/Documentation/Documentation%20-%20Draft/Networking/5454%20Mach-1%20AP/User%20Guide/English/tut_bridge.html
8. If other Bridges will be connecting to this access point, select the checkbox next to I want to
specify the devices that can connect to this one under WDS Restrictions. You will then
need to enter the wireless MAC address of each new Bridge you will be connecting to this one
and then click Add. By default, this feature is disabled. USRobotics recommends that you only
add one more Bridge in this fashion. If you add more than one Bridge in a chain, you will begin
to lose network quality and speed.
Note: If the WDS channel of the networking device that the access point is
connected to changes, the
Status page will continue to show the old channel
information for the access point. Although the Network list on the
Wireless
page will display the selected network and the correct channel, the change has
not yet been applied to the access point. To update the channel information on
the access point, click Save at the bottom of the
Wireless page.
9. Select or enter any required
Transmission settings that you will need to connect to the
wireless network device.
10. Click Save at the bottom of the page.
file:///G|/CSO/Documentation/Documentation%20-%20Dr...%20Mach-1%20AP/User%20Guide/English/tut_bridge.html (3 of 4)10/26/2006 9:47:12 AM