User's Manual

T-311 11Mb High Gain Smart Ethernet Client User’s Guide
Gemtek Systems Page 26
7.Troubleshooting
Q: It’s difficult to connect this device with exist wireless network.
A: There are several possible causes based on the way the High Gain Smart Ethernet Client
is connected to the network.
a. Problems on the wireless side
Always check the status of the LEDs to verify if you have:
♦ Electricity problems,
♦ Radio signal problems,
♦ Networking problems
1. Possible cause: Is the High Gain Smart Ethernet Client powered up?
Solution: Check the power LED. Check if the High Gain Smart Ethernet Client is
connected.
2. Possible cause: Is the High Gain Smart Ethernet Client is in range of the
Access Point?
Solution: Check the WLAN signal LED. Check for possible problems with
respect to range.
3. Possible cause: Is there a network connection? Check the network LINK LED.
Solution: The High Gain Smart Ethernet Client may take up to a minute to find
an IP address.
b. Problems on the wired side
Always check if your cables and connections are in good order and properly
installed.
1. Possible cause: Has the proper cable been used?
Solution: ·If the High Gain Smart Ethernet Client connects to a HUB, a