User's Manual Part 1

The MAC Access Control page allows you to control which local client computer is allowed to
access the network through the Dell Wireless 4350 Small Network Access Point based on the
client computer’s MAC address. The default setting is to allow any client computer to access
the network through the access point.
There are two options for the Access Control Settings, the Allow Access option and the Deny
Access option. Each option is able to support up to 32 entries. Only one option can be active at
any time. Selecting the checkbox for Enable Allow Access will disable Enable Deny Access and
vice versa. The Enable Allow Access option will only allow clients that are listed in the table to
access the network. The Enable Deny Access option will prevent any clients that are listed in
the table from accessing the network.
To enable MAC Access Control, perform the following steps:
1. Click to select Enable MAC Access Control.
2. Click the appropriate option, Enable Allow Access or Enable Deny Access.
3. Click the Add button. The MAC Access Control: Add a Record window appears.
4. Enter the hexadecimal MAC address (for example, 00:11:22:33:44:55) that you want to
grant or deny access in the Host MAC box.
5. Click the OK button to apply, or click the Cancel button to exit without making any
changes.
6. You can click on the selected record and click again on its Host Name to enter the desired
name for this record.
7. Click the Apply MAC Control Settings button on the bottom of the screen to activate the
new settings.
Administration