User Manual

Gemtek Systems Page 24
Wireless Configuration Settings
Access Point SSID
Depending on the device mode selection, parameters available in the Wireless Configuration Settings
page will vary. Because of the complexity and quantity the wireless parameters are spitted into the
simple units.
Figure 14 -- Wireless Configuration Settings (1)
Access Point SSID is a unique name for your wireless network. It is case sensitive and must not
exceed 32 characters. The default SSID is "
xxxxx " but you should change this to a personal wireless
network name.
The SSID may not contain special characters like [ ] { } / \ or spaces. Only dots and
underscores are allowed.
In Access Point mode SSID must be made known to all mobile clients, or they have to use the “auto
connect to any wireless network” function in their WLAN card.
If you are running more than one P-360 and want to enable the roaming function, please use the
same SSID in all access points.
Domain/Channel
Figure 15 – Wireless Configuration Settings (2)
Domain: full frequency range of the 2.4 GHz ISM band is not permitted to be used in all countries.
Depending on the selection of the regulatory domain here the available frequency channels will vary.
Channel: Frequency channels are used to avoid interference between nearby access points. If you
wish to operate more than one access points in overlapping coverage areas, we recommend a
distance of at least four channels between the chosen channels. For example, for three Access Points
in close proximity choose channels 1, 5 and 11.
Refer to the regulatory domains chapter in the appendix to get more information
concerning the regulations valid for your country and set the parameters for
frequency channel to the permitted values!