User's Manual

6
3 Configuring the Wireless Ethernet Adapter
The Wireless Ethernet Adapter is a ready to use device. It is delivered with default
settings which allow you to have access to it without configuring it.
You configure the Wireless Ethernet Adapter via a JavaScript-enabled web-browser such
as the Internet Explorer 4.0 or higher, or the Netscape Navigator 4.0 or higher.
Factory Default Settings for the Wireless Ethernet Adapter
SSID default
Channel 6
Transmission rates Auto
WEP enable No
IP Address mode Static
IP Address 192.168.5.99
Subnet mask 255.255.0.0
User Name Blank
Administrator or password Blank (no password needed)
When you do configure the Wireless Ethernet Adapter, you can change the
settings with respect to security, radio channels, etc.
The computer that you are using for initial configuration must have an IP
Address within the same range as the IP Address of the Wireless Ethernet
Adapter.
The Wireless Ethernet Adapter has a default IP Address of 192.168.5.90 with a
subnet mask of 255.255.0.0