User Manual

Connecting the DWL-810 Ethernet-to-Wireless

Bridge to your Ethernet-enabled device

A. First, connect the power adapter to the receptor at the back panel of the

DWL-810 and then plug the other end of the power adapter to a wall

outlet or power strip. The Power LED will turn ON to indicate proper

operation.

B. Insert one end of the Cross-Over Ethernet cable (included) to the Ethernet

port on the back panel of the DWL-810 and connect the other end to the

Ethernet port located on the device (e.g., a Set Top Box, Gaming Console,

laptop or desktop computer, or network printer.) The LED light will

illuminate to indicate proper connection.

C. The antenna is used by the DWL-810 to connect to other 802.11b

wireless devices.

If you are wirelessly connecting the DWL-810 to an

Access Point or Wireless Router on a larger wireless

network, additional configuration is required (see

Step 3 )

No configuration of the DWL-810 is needed if your setup is

similar to Setup #1 (shown on the following page, in Step 2.)