User Manual

Parameter Default value Range Description
zone_privacy {[on | off]} off on or off Enables the zone privacy feature.
For a full list of parameters available in Nokia A036, see Set command
parameters.
5.7 Configuring DHCP
Use the command line interface to configure DHCP settings.
Configuring DHCP Relay
As Nokia A036 supports both IEEE802.1x and open system authentication, every
Access Point has a DHCP relay function with two DHCP pools. The DHCP relay
function acts as a standard BOOTP relay, checking the terminal's authentication
type and forwarding DHCP queries to the relevant DHCP server. The DHCP
relay function is based on RFC1534 and the DHCP server on RFC2131.
To configure DHCP relay function, set the following parameters using the set
command:
Parameter Default value Range Description
dhcp_relay {[on | off]} off on or off Enables the DHCP relay func-
tionality.
ip_address_1x {dotted-
quad}
none IP address IP address of the AP to be used
in DHCP relay when forwarding
requests for 802.1x users
(giaddr).
ip_address_OpenSystem
{dotted-quad}
none IP address IP address of the AP to be used
in DHCP relay when forwarding
requests for OpenSystem users
(giaddr).
Configuring DHCP server
You can also use Nokia A036 as a DHCP server by setting the following
parameters with the set command:
42 (60) # Nokia Corporation
Nokia Proprietary and Confidential
dn02119532
Issue 1-0 en
Nokia A036 Wireless LAN Access Point User Manual