User's Manual

ADIMOS ** Company Confidential **
WVM User Manual Page 11 of 12 Rev 1.10
3.2.13 Wireless ID
Sub-
addr
Name R/W Size
[bytes]
Value Default
0x1A Wireless ID
(Rx only)
R 16
Byte0-15 = Value of wireless ID
string.
N/A
The Wireless ID string is a 128-bits (16-bytes) string, which identifies the Rx unit. It is used for
communicating to the Rx unit from a PC equipped with Adimos PC Connectivity product.
3.2.14 RSSI Status
Sub-
addr
Name R/W Size
[bytes]
Value Default
0x1B RSSI status R 1
Byte0 = 0-0x46 (0-70): RSSI in
dB units
N/A
RSSI is an acronym for Received Signal Strength Indication. The RSSI value measures the signal relative to
a calibrated noise floor. The noise floor is measured over the relevant bandwidth over a long time, and the
minimum value establishes the calibrated noise floor.
The RSSI on the Rx side relates to the video stream direction; the RSSI on the Tx side relates to the
Acknowledge packets direction.
The RSSI is updated every 100 mSec.
3.2.15 PER Status
Sub-
addr
Name R/W Size
[bytes]
Value Default
0x1F PER status R 1
Byte0 = 0-0xC7 (0-199): PER in
0.5% units (e.g., 2 means PER of
1%)
Byte0 = 0xC8 (200): the unit is not
connected to a peer unit.
N/A
PER is an acronym for Packet Error Rate. While in video transmission, the PER is measured and updated at
the Tx unit every 300 mSec.
Special values of the PER status register:
 When the unit is not connected, waiting for a peer unit to connect, PER status register is 200.
 When the unit is in sleep mode and connected to a peer unit, PER status register is 0.
3.2.16 Do Installation Process
Sub-
addr
Name R/W Size
[bytes]
Value Default
0x22
Do Installation
Process
(Tx only)
W 1
Byte0 = 1: Do normal installation
process
Byte0 = 2: Do temporary installation
process
N/A