User Manual

11
Step 2. Startup
Note: Make sure all Ethernet cabling is complete before performing this task.
1. Turn off power to your PC, router (if you have one), modem or gateway.
Note: If equipped with a backup battery, it may be necessary to press “reset” on your modem or gateway. See the user
documentation for your device.
Make sure all of the devices are turned off before you go to the next step.
2. Wait a minute, then turn on the modem or
gateway first, the router second (if you have
one), and the PC last. Wait a few moments
before turning on each device.
3. Find the AC adapter that came with your
MicroCell and connect it as shown.
4. Verify the status of your devices.
• Make sure that the Power status
indicator on the front panel is steady
green and that the Ethernet and PC
status indicators are flashing or steady
green.
• Make sure that the status indicators on
your router (if you have one), modem or
gateway are operating as they normally
do (this may take a few minutes).
5. Open a browser on your PC and connect
to the Internet.
Antenna
Computer
Ethernet
Power
Reset
MicroCell
3G
AT&T 3G
MicroCell
™
AC Power
Adapter
Power
Outlet
T14078
3
Go to the AT&T 3G MicroCell™ home page: att.com/3GMicroCell
If you can connect to the MicroCell home page, then you have performed the Ethernet Cabling and Startup tasks correctly.
Congratulations! Go to Step 3. Account Activation.
What if you can’t connect to the AT&T 3G MicroCell™ home page?
If you are having trouble connecting to the Internet, confirm Step 1. Ethernet Cabling and Step 2. Startup. If that doesn’t
help, refer to the Troubleshooting section on page 15.
4030453_RevA_6.75x8.25_Mar6.indd 114030453_RevA_6.75x8.25_Mar6.indd 11 3/6/2009 5:43:33 PM3/6/2009 5:43:33 PM