User Manual

560550-0128 Issue A Page 3 of 4
OPERATIONAL LIFE:
Limited to 100M cycles to maximum allowable pressure.
WARRANTY
We guarantee this instrument against faulty workmanship and material for a period of two years
from date of delivery. The Company undertake to repair, free of charge, ex-works any instrument
found to be defective within the specified period providing the instrument has been used within
the specification in accordance with these instructions and has not been misused in any way.
Detailed notice of such defects and satisfactory proof thereof must be given to the Company
immediately after the discovery and the goods are to be returned free of charge to the Company,
carefully packed and accompanied by a detailed failure report. See "RETURN TO FACTORY".
WETTED PARTS
316L stainless steel.
SERVICING
The transducer cannot be repaired locally and if damaged should be returned to ourselves at the
address shown below or to accredited dealers when a replacement/repair is required:
Gems Sensors & Controls Gems Sensors Inc
Lennox Road 1 Cowles Road
Basingstoke Plainville, CT 06062
Hants. RG22 4AW U.S.A.
RETURN TO FACTORY
PLEASE NOTE: To comply with Health and Safety requirements, the instrument must be clean
and safe to handle and accompanied by a formal statement to that effect duly signed by an
authorised officer of the Company.
Any instrument returned without certification will be quarantined and no action will occur until
cleared. It may ultimately be returned to you and subject to a transportation charge.
MAINTENANCE
Routine Inspection: Not required except for periodic inspection of the cable and connector to
ensure that these are neither damaged nor softened by incompatible liquid.