Full Product Manual
3
2. Control Elements
1. MIC Use this balanced XLR jack to connect microphone to the mixer.
2.
3. Use the GAIN control to adjust the input gain. This control should always be
turned fully counterclockwise when ever you connect or disconnect a signal
source to one of the inputs.
4. In addition, the mono channels are equipped with a steep LOW CUT filter
(slope at 18 dB/oct, -3 dB at 75 Hz) designed to eliminate unwanted low-
frequency signal components.
The upper (HIGH) and the lower band (LOW) are shelving filters that
increase or decrease all frequencies above or below their cut-o frequency.
The cut-o frequencies of the upper and lower band are 12 kHz and 80
Frequency of 2.5 kHz.
The PK LED’s of the mono channels illuminate when the input signal is
driven too high, which could cause distortion. If this happens, use the GAIN
control to reduce the preamp level until the LED does not light anymore.
more channels and sum these signals to a bus. The bus appears at the
device. The return from the eects unit is then brought back into the
+10 dB gain.
The PAN control determines the position of the channel signal within the
The LEVEL control determines the level of the channel signal in the main
mix.
for left (L/MONO) and right (R) channels. If you use only the (L/MONO)
jack , same sound is output from both Left and right speakers.
individual channels using the EFF SEND controls. You can connect this to
the input of an external eects device in order to process the EFF bus’
• The phantom power required for condenser mics can be activated with
+48V PHANTOM switch.
Channels 1-4 feature an additional line input on a balanced 1/4” jack.
5-7.
Hz respectively. The (MID) band is configured as a peak filter with a center
8.
9. FX sends enable you to feed signals via a variable control from one or
console’s FX sent output and can be fed from there to an external effects
console on the stereo channels. Each FX send is mono and features up to
10.
stereo image. Turning PAN knob left will send Audio to the left side of
MASTER output and vice versa.
11.
12. LINE IN Each stereo channel has two balanced line level inputs on 1/4” jacks
13. The EFF SEND connector outputs the signal you picked up from the