Operation Manual

ManualsBrandsGemini ManualsCar alarm862

Made in Italy

AC 2710/UK Rev. 01 - 02/12

863 - 863/24

862

861

- 862/24

INSTALLATION AND

USE MANUAL

INSTALLATION CERTIFICATE

The undersigned qualified installer attests to have personally fitted the here described vehicle

security system following the manufacturer instructions.

................................................

..........................................................................................................................

By :

Sold on :

T:ype of product

Vehicle :

862

863

861

GEMINI Technologies S.p.A.

Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia

Tel. +39 0332 943211 - Fax +39 0332 948080

Web site: www.gemini-alarm.com

Reg. n.532-A

UNI EN ISO 9001:2008

Summary of content (8 pages)

PAGE 1
INSTALLATION CERTIFICATE The undersigned qualified installer attests to have personally fitted the here described vehicle security system following the manufacturer instructions. By : 863 Sold on : Type of product : 862 ................................................ 861 863 - 863/24 862 - 862/24 861 INSTALLATION AND USE MANUAL Vehicle : .......................................................................................................................... UK GEMINI Technologies S.p.A.
PAGE 2
UK 1.0 - PRELIMINARY ADVICE............................................................................................. PAGE 03 USER MANUAL 2.0 - OPERATING DESCRIPTION..................................................................................... PAGE 03 2.1 - Complete system arming......................................................................................... PAGE 04 2.2 - System arming with siren sound exclusion.............................................................. PAGE 04 2.
PAGE 3
2.1 - COMPLETE SYSTEM ARMING Press the push-button nr.1 (padlock closed) of the remote control or insert the electronic key into the specific receptacle. The system arming is confirmed by two acoustic signals and two flashes of the turn signals. The system has a 35” pre-arming “neutral time” (indicated by LED's permanent turning on). 2.2 - SYSTEM ARMING WITH SIREN SOUND EXCLUSION This function allows the user to arm the alarm system, excluding the siren sound in case of a theft attempt.
PAGE 4
3.0 - NEW PIN-CODE PROGRAMMING 4.0 - EMERGENCY DISARMING BY PIN-CODE The procedure to program pin-code is specified here below as previously described, it is better to personalize as customer has required. In this example reported below, supposing that the pin-code is 5-4-6-7. The procedure for emergency disarming by pin-code is following, reported below. Kindly note that the standard pin-code programmed is of the four digit 1-1-1-1.
PAGE 5
INSTALLER MANUAL 8.0 - COMPLETE ELECTRIC DIAGRAM 6.
PAGE 6
9.0 - PROGRAMMABLE FUNCTIONS DESCRIPTION In this chapter various functions of the system are concisely described; for programming please follow the instruction given in paragraph “SYSTEM PROGRAMMING”. 9.1 - ACOUSTIC SIGNALLING This function activates acoustic signals during system arming (2) and disarming (3). 9.
PAGE 7
11.0 - ADDING NEW DEVICES ! To carry out the operation successfully, make sure the required electrical connections (door push-button, bonnet push-button and positive under key) are complete. ! Storing memory is for 50 devices. If an extra device is added, it automatically deletes the first device programmed in the system memory. To activate the procedure proceed as follows: ! With system disarmed, open the driver side door and the bonnet and leave them open.
PAGE 8
13.0 - ULTRASONIC VOLUMETRIC PROTECTION 15.0 - WARRANTY CONDITIONS 13.1 - CONNECTIONS AND POSITIONING Insert the WHITE connector in the the “W” socket on the control unit. Insert the RED connector in the “R” socket on the control unit. Install the transducers of the ultrasonic sensors in the uppermost part of the windscreen internal pillars, away from the aeration inlets and orient them towards the center of the rear window. 13.