Operation Manual

PAGE 08 - INSTALLER MANUAL INSTALLER MANUAL - PAGE 09
8.0 - CONNECTION FOR TURN SIGNALS ACTIVATION
GEMINI 822
SYSTEM
GEMINI 822
SYSTEM
GEMINI 822
SYSTEM
ORANGE
WHITE-ORANGE
ORANGE
ORANGE
WHITE-ORANGE
ORANGE
8.2 - CONNECTIONS ON VEHICLES WITH SEPARATE LINES
8.3 - CONNECTIONS TO HAZARD PUSH-BUTTON
VEHICLE
ELECTRICAL
EQUIPMENT
BLUE
WHITE-ORANGE wire to be connected
ONLY if system operates through turn
indicators.
WHITE-ORANGE wire to be connected
ONLY if system operates through turn
indicators.
Insert nr. 6
2 Ampere
diodes.
S
.
elect “visual impulse
signals” in “SYSTEM
PROGRAMMING” menu.
Do not use if system
operates through turn
indicators
9.0 - CENTRAL DOOR LOCKING CONNECTIONS TO ARM SYSTEM
!
“ON”.
“C”, “D”, “E” connection).
“ON”.
9.1 -
9.2 -
9.3 - CONNECTIONS TO THE TURN INDICATORS
Central door locking must be connected according to vehicle type (see installation diagrams).
The various arming modes are listed below and the connections indicated in the following
paragraphs.
Arming through door locking motor unit.
Arming through door locking motor unit and locks control switches.
Arming through self-learning of turn indicators signals.
Arming through turn indicators signals and door locking motor unit.
Arming through turn indicators signals, door locking motor unit and locks switches.
Arming/disarming connections for vehicles with radio receiver separated from CDL (see www.gemini-
alarm.com for diagram “A” connection).
Set dip-switch nr. 4
Arming/disarming connections for vehicles that require not only connections to door locking motor unit
but also control of lock switch or of internal door lock buttons (see www.gemini-alarm.com for diagram
Set dip-switch nr. 4
!
!
!
!
CONNECTIONS - DOOR LOCKING MOTOR UNIT WITH SEPARATE RADIO RECEIVER
CONNECTIONS - DOOR LOCKING MOTOR UNIT WITH LOCK SWITCH
Connect door locking motor unit, if turn indicators signals are identical on locking and
unlocking.
If the turn indicators flash when unlocking with the car mechanical key, do not make this
connection.
!
!
The arming/disarming connection is made by connecting the WHITE-ORANGE wire to the turn
indicators.
If arming/disarming connection is activated only by turn indicators, set dip-switch nr. 4 “OFF”.
If arming/disarming connection is activated by turn indicators and door lock motor unit, set dip-switch
nr. 4 “ON”.
LEFT TURN
INDICATORS
RIGHT TURN
INDICATORS
TURN INDICATORS
CONTROL UNIT
Front
SX
Rear
DX
Side
SX
Side
DX
Rear
SX
Front
XD
8.1 - CONVENTIONAL CONNECTION