7833 7832 INSTALLER AND USER MANUAL UK For all EU Countries AC XXXX Rev.
UK 3.0 - FUNCTIONS 1.0 - CONTENTS 1.0 - CONTENTS..... ....................................................................................................... 2.0 - GENERAL NOTE FOR INSTALLATION.................................................................. 3.0 - FUNCTIONS........................................................................................................... 4.0 - OPERATING DESCRIPTION................................................................................. 4.
!Press the lock button of the vehicle's original radio control or insert the electronic key into the receptacle. !Two acoustic signals and the number of optical signals that has been programmed by the car's manufacturer will indicate that the system has been armed. It is possible to carry out the complete disarming procedure only when the system is armed, during one alarm cycle or during the neutral time between two alarm cycle but not during the arming neutral time.
6.0 - CONNECTOR TABLE 8.
9.0 - PROGRAMMING THE ALARM SYSTEM The table given below is applied to the alarm programmed in "standard configuration". FUNCTION Acoustic signallig STATE Enabled Impulse optical signals Disabled Optical signals by arming/disarming Disabled Alarm passive arming Disabled Management “Negative comfort” or “Satellite system activation” Satellite system activation 10.
12.0 - EXAMPLE OF ALARM MODULE CODE PROGRAMMING 11.0 - VEHICLE CODE PROGRAMMING In presence of a CAN-BUS line, the alarm needs a configuration depending on the vehicles model and make. The alarm is supplied without any programming, since Gemini does not know the vehicle on which the module will be installed. For this reason, programming has to be carried out during installation. Indeed, even in the same vehicle's brand, operating differences are possible, according to the model (es. Coupè o station wagon).
13.0 - ADD NEW ELECTRONIC KEY The alarm can memorise upto a maximum of 4 electronic keys. Programming is directly depending on the connection of GREEN wire which protects the grounded hood. If this connection was not required, since bonnet opening is detected by CAN-BUS signals, before starting new electronic key programming, connect this wire to earth. Than proceed as described below: !With the system disarmed, turn the vehicle ignition key in “ON” position.
