Installation Instructions

GEMINI 7025
DESCRIPTION.
Gemini 7025 is a self-powered, high power, electronic siren studied to install in the vehicle’s engine compartment. To install
the siren in the engine compartment use the bracket and the screws supplied with the kit and follow the fitting instructions.
Install the siren on the vehicles bodywork away from areas of intense heat.
WIRING CONNECTIONS (for the installer)
Disconnect the negative terminal of the battery and only re-connect after the installation is complete.
WIRE COLOUR FUNCTION
BLACK marked RB ê Battery positive terminal
BLACK marked MB ê Battery negative terminal
BLACK marked S ê To the alarm PINK wire
BLACK marked R ê To the alarm RED wire
BLACK marked L ê To the alarm BLUE wire
NOTE: connect the BLACK wire of the unit to earth.
Connect one end of the BLACK initialled V wire to the bonnet pin switch and the other end to the alarm GREEN wire.
NOTE: To disarm the alarm unit and the engine immobilisation, turn the siren key to off. The internal battery recharges
with alarm disarmed.
TECHNICAL DATA
Power supply 12V
Current absorption alarm ON 3mA
Current absorption alarm OFF 7Ma (recharging battery).
Audible tone > 118dB
Note: To avoid any damaging do not steam clean directly to the siren.
GEMINI 725
DESCRIPTION.
Gemini 725 is a self-powered, high power, electronic siren studied to install in the vehicle’s engine compartment. To install the
siren in the engine compartment use the bracket and the screws supplied with the kit and follow the fitting instructions.
Install the siren on the vehicles bodywork away from areas of intense heat.
WIRING CONNECTIONS (for the installer)
Disconnect the negative terminal of the battery and only re-connect after the installation is complete.
WIRE COLOUR FUNCTION
RED
ê Battery positive terminal
BLACK
ê Battery negative terminal
BLUE
ê To the alarm unit YELLOW-BLACK wire
NOTE: connect the BLACK wire of the unit to earth.
INSTALLATION.
Install the siren in the engine compartment away from areas of intense heat using the bracket and the screws supplied with the kit.
TECHNICAL DATA
Power supply 12V
Current absorption 7mA (recharging battery)
Audible tone > 118dB
Note: to avoid any damaging do not steam clean directly to the siren.
This device is guaranteed against any manufacturing or working fault for 12 months from purchase date. The manufacturer declines
every responsibility for any defect or failure to the device and to the electric plant of the vehicle due to an incorrect installation or to the
alteration of the technical data stated in this manual.