Operation Manual

The exit delay period is 15 sec. for each alarm.
Attention : do not turn the unit on with the key switch before the installation is complete. You
must then wait for a maximum of 60 minutes before completing the self-powered test. All
other alarm functions will perform as standard.
If You want to wash the engine of the car, please take care do not steam clean.
DIP SWITCH PROGRAMMING TABLE.
1 ON Current drawn active.
OFF Current drawn isolated.
2 ON Acoustic activation/de-activation isolated.
OFF Acoustic activation/de-activation active.
3 ON Passive arming active.
OFF Passive arming isolated.
4 ON Self-learning active.
OFF Self-learning isolated (normal use).
TECHNICAL DATA
Protection degree mechanic closure IP54
Power supply 10.5-14.5m VDC
Working temperature -30° + 85°
Current drawn alarm ON 12mA
Current drawn alarm OFF 10 mA
Nominal voltage backup battery (6103-6103IR) 7,2 V
Capability backup battery (6103-6103IR) 170mAh
Engine immobilisation relay contact capability 8A continuous
Central door locking relay contact capability 10A continuous
Alarm cycle 30 seconds
Siren audible level at 1 meter in open space > 114 dB
Minimum power absorption required to trigger 5W
Max. current for control positive alarm armed 500 mA
Max. current for control supplementary siren
with negative control 500 mA
The manufacturer declines every responsibility for any possible defect or failure to the device and to the vehicle’s
electric system due to incorrect installation or to the alteration of the indicated Technical Features. The alarm system
has only a dissuasive function against possible thefts.
Gemini Trading S.r.l. reserves the right to execute modifications whenever it is needed without prior notice.