User manual

4
EG-SSWS3-01
Smart switching wireless socket set, 3 channel, Shuko, 16 A
All brands and logos are registered trademarks of their respective owners
REMOTE CONTROLLER
 Install the provided battery in the remote control's
battery compartment, making sure the polarity of the
battery is correct.
 Plug a receiver socket in wall power socket, then
LED indicator will be lighted up. And LED flashes
one time per second. If LED won’t flash, please
press and hold the ON-OFF button on the socket for
3 seconds until the LED indicator begins to flash.
The socket is ready to be connected to the remoter.
 Press and hold the ON button you have chosen for 2
seconds on the remoter. The LED on the socket will
begin to flash rapidly and then stop, the socket is
connected successfully.
 Repeat above last two steps, choosing a different ON button on the
remoter for each socket.
 To check that connection has been successful, press the relevant 'ON'
and 'OFF' buttons; the LED on the socket will be switched on and off.