User manual

23
EG-PM2-LAN PROGRAMMABLE POWER
OUTLET STRIP WITH LAN INTERFACE
All brands and logos are registered trademarks of their respective owners
Below the page you can see the current time of the web-server and
eventual information about the last successful timer synchronization.
Automatic timer synchronization is used if Use NTP for timer correction
option is enabled (see section 4.6 below).
NOTE: If a certain socket has a switching fault, e.g. it should be
switched on but the whole device is switched off, or it should be off but it
does have voltage, then the warning message Wrong voltage on socket!
will be shown above the Event schedule (see Figure #7 above). This
message might also indicate that this socket is defective.
For setting up the socket schedule click Set schedule button. You
will face then the page shown below (see Figure #8).