User Manual
Table Of Contents
- Document History
- Introduction
- Product Concept
- GSM Application Interface
- GSM/GPRS Operating Modes
- Power Supply
- Power Up / Down Scenarios
- Automatic GPRS Multislot Class Change
- Charging Control of the GSM Part
- Power Saving
- Summary of State Transitions (Except SLEEP Mode)
- RTC Backup for GSM Part of XT55/56
- Serial Interfaces of the XT55/56 GSM Part
- Audio Interfaces
- SIM Interface
- Control Signals
- GPS Application Interface
- GSM and GPS Antenna Interfaces
- Electrical, Reliability and Radio Characteristics
- Mechanics
- Reference Approval
- Example Applications
- List of Parts and Accessories
XT55/56 Hardware Interface Description
Confidential / Preliminary
s
XT55/56_hd_v02.96 Page 118 of 125 18.08.2005
8.2 Compliance with FCC Rules and Regulations (XT55 only)
The FCC Equipment Authorization Certification for the XT55 reference application described
in Chapter 8.1 is listed under the
FCC identifier QIPXT55
IC: 267W-XT55
granted to Siemens AG.
The XT55 reference application registered under the above identifier is certified to be in
accordance with the following Rules and Regulations of the Federal Communications
Commission (FCC).
“This device contains GSM 900MHz and GSM 1800MHz functions that are not
operational in U.S. Territories.
This device is to be used only for mobile and fixed applications. The antenna(s) used
for this transmitter must be installed to provide a separation distance of at least 20 cm
from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter. Users and installers must be provided with antenna installation
instructions and transmitter operating conditions for satisfying RF exposure com-
pliance. Antennas used for this OEM module must not exceed 7dBi gain for mobile and
fixed operating configurations. This device is approved as a module to be installed in
other devices.”
The FCC label of the module must be visible from the outside. If not, the host device is
required to bear a second label stating, “Contains FCC ID QIPXT55”.
Manufacturers of mobile or fixed devices incorporating XT55 modules are advised to include
instructions according to the above mentioned RF exposure statements in end product user
manual.
Please note that changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.