User's Manual

PH8/PH8-P Hardware Interface Overview
8.2 Compliance with FCC and IC Rules and Regulations
44
PH8_PH8-P_HD_v02.000 Page 44 of 46 2011-10-21
Confidential / Released

8.2 Compliance with FCC and IC Rules and Regulations
The Equipment Authorization Certification for the Cinterion Wireless Modules reference appli-
cation described in Section 8.1 will be registered under the following identifiers:
•PH8:
FCC Identifier QIPPH8
Industry Canada Certification Number: 7830A-PH8
Granted to Cinterion Wireless Modules GmbH
•PH8-P:
FCC Identifier QIPPH8-P
Industry Canada Certification Number: 7830A-PH8P
Granted to Cinterion Wireless Modules GmbH
Manufacturers of mobile or fixed devices incorporating PH8/PH8-P modules are authorized to
use the FCC Grants and Industry Canada Certificates of the PH8/PH8-P modules for their own
final products according to the conditions referenced in these documents. In this case, the FCC
label of the module shall be visible from the outside, or the host device shall bear a second label
stating "Contains FCC ID QIPPH8" resp. "Contains FCC ID QIPPH8-P", and accordingly “Con-
tains IC 7830A-PH8“ resp. “Contains IC 7830A-PH8P“. The integration is limited to fixed or mo-
bile categorised host devices, where a separation distance between the antenna and any
person of min. 20cm can be assured during normal operating conditions. For mobile and fixed
operation configurations the antenna gain, including cable loss, must not exceed the limits that
are stated on the FCC Grant.
IMPORTANT:
Manufacturers of portable applications incorporating PH8/PH8-P modules are required to have
their final product certified and apply for their own FCC Grant and Industry Canada Certificate
related to the specific portable mobile. This is mandatory to meet the SAR requirements for por-
table mobiles.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.