User's Manual


PDS8
_
HIO_v02.800
Confidential / Preliminary
2014-10-27
Cinterion
®
PDS8 Hardware Interface Overview
5.4 Compliance with FCC and IC Rules and Regulations
Page 27 of 35
5.4 Compliance with FCC and IC Rules and Regulations
The Equipment Authorization Certification for the Gemalto M2M reference application de-
scribed in Section 5.3 will be registered under the following identifiers
1
:
FCC Identifier: QIPPDS8
Industry Canada Certification Number: 7830A-PDS8
Granted to Gemalto M2M GmbH
Manufacturers of mobile or fixed devices incorporating PDS8 modules are authorized to
use
the FCC Grants and Industry Canada Certificates of the PDS8 modules for their own
final
products according to the conditions referenced in these documents. In this case, an FCC/
IC
label of the module shall be visible from the outside, or the host device shall bear a second
label stating "Contains FCC ID QIPPDS8", and accordingly “Contains IC 7830A-PDS8“. The
integration is limited to fixed or mobile categorised host devices, where a separation dis-
tance between the antenna and any person of min. 20cm can be assured during normal oper-
ating conditions. For mobile and fixed operation configurations the antenna gain, including
cable loss, must not exceed the limits 2.15 dBi (850 MHz) and 2.15 dBi (1900 MHz).
IMPORTANT:
Manufacturers of portable applications incorporating PDS8 modules are required to have
their
final product certified and apply for their own FCC Grant and Industry Canada Certificate
related to the specific portable mobile. This is mandatory to meet the SAR requirements for por-
table mobiles (see Section 5.2 for detail).
FCC Regulations
WARNING:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two con
ditions: (1) This device may not cause harmful interference, and (2) this device must accept any i
nterference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
IC Regulations
IC Notice This device complies with Industry Canada license‐
exempt RSS standard(s). Operation is subject to the following two conditions:
1) this device may not cause interference, and