User's Manual
PCS3_HD_v01.000
Confidential / Preliminary
Page 95 of 101 2013-10-21
PCS3 Hardware Interface Description
9 Reference Approval
U ra n us
9
Reference Approval
9.1 Reference Equipment for Type Approval
The Cinterion Wireless Modules reference setup submitted to type approve PCS3 is shown in
Figure 48. The module (i.e., the evaluation module) is connected to the DSB75 by means of a
flex cable and a special DSB75 adapter. The CDMA test equipment is connected via
edge
mount SMA connectors soldered to the module’s antenna pads.( (Only Main Antenna of
PCS3, Didn’t have GPS)
For ESD tests and evaluation purposes, it is also possible connect the module to the CDMA
test equipment through an SMA-to-Hirose-U.FL antenna cable and the SMA antenna
connectors of the DSB75 adapter.
A further option is to mount the evaluation module directly onto the DSB75 adapter’s 80-pin
board-to-board connector and to connect the test equipment as shown below.
Aud io
te st equ ipm ent
De tail:
Vo tro nic
han dse t
E dg e m o u nt S M A c on n ec to r s
m an ua lly so ld ered to an ten na pa ds
P CS3
eva lua tion
m o dule
S ta n da rd
80 polig Flex
PCS3
evaluation
m odu le
US B
D S B 7 5 a d a p t e r
CO M 1
(ASC 0)
GNS S
test eq uipm en t
GN S S
AN T 3
CD M A
test eq uipm en t
CDM A D rx
C D M A M a in
US B
ca ble
AN T 2
AN T 1
Au dio
A udio
DSB7 5
Pow e r
GN D
Po w er
PC
supp ly
RS 2 32
cab le
Figure 48: Reference equipment for type approval