User's Manual
Table Of Contents
- Contents
- Tables
- Figures
- 1 Introduction
- 2 Interface Characteristics
- 2.1 Application Interface
- 2.1.1 Pad Assignment
- 2.1.2 Signal Properties
- 2.1.3 USB Interface
- 2.1.4 Serial Interface ASC0
- 2.1.5 Serial Interface ASC1
- 2.1.6 UICC/SIM/USIM Interface
- 2.1.7 Digital Audio Interface
- 2.1.8 Pulse Code Modulation Interface (PCM)
- 2.1.9 Inter IC Sound Interface (I2S)
- 2.1.10 GPIO Interface
- 2.1.11 I2C Interface
- 2.1.12 SPI Interface
- 2.1.13 Pulse Counter
- 2.1.14 HSIC Interface (ELS51-VA Only)
- 2.1.15 SDIO Interface (ELS51-VA Only)
- 2.1.16 Control Signals
- 2.2 RF Antenna Interface
- 2.3 Sample Application
- 2.1 Application Interface
- 3 Operating Characteristics
- 3.1 Operating Modes
- 3.2 Power Up/Power Down Scenarios
- 3.3 Power Saving
- 3.4 Power Supply
- 3.5 Operating Temperatures
- 3.6 Electrostatic Discharge
- 3.7 Blocking against RF on Interface Lines
- 3.8 Reliability Characteristics
- 4 Mechanical Dimensions, Mounting and Packaging
- 5 Regulatory and Type Approval Information
- 6 Document Information
- 7 Appendix
Cinterion
®
ELS31-VA/ELS51-VA Hardware Interface Description
2.1 Application Interface
56
ELS31-VA_ELS51-VA_HID_v01.000 2017-01-04
Confidential / Preliminary
Page 35 of 106
The following figure shows the startup behavior of the GPIO interface. With an active state of
the ASC0 interface line CTS0, the initialization of the GPIO interface lines is also finished.
*) For pull down values see Table 15.
Figure 13: GPIO startup behavior
GPIO1 - 8 Hi-Z
CTS0
ON
EMERG_RST
Power supply active
Start up
Firmware
initialization
Command interface
initialization
Interface
active
V180
VCORE
GPIO16 - 27
Hi-Z
Reset
state