User's Manual

Cinterion
®
AGS2-E Hardware Interface Overview
8 Reference Approval
37
 AGS2-E_HIO_v00.021 2014-03-20
Confidential / Preliminary
Page 36 of 40
8 Reference Approval
8.1 Reference Equipment for Type Approval
The Gemalto M2M reference setup submitted to type approve AGS2-E is shown in the follow-
ing figure
1
. The module (i.e., the evaluation module) is connected to the DSB75 via a special
adapter and either mounted directly onto the adapter or connected using a flex cable:
Figure 9: Reference equipment for Type Approval
1. For RF performance tests a mini-SMT/U.FL to SMA adapter with attached 6dB coaxial attenuator is cho-
sen to connect the module directly to the GSM/UMTS/GNSS test equipment instead of employing the
SMA antenna connectors on the AGS2-E-DSB75 adapter as shown in Figure 9. The following products
are recommended:
Hirose SMA-Jack/U.FL-Plug conversion adapter HRMJ-U.FLP(40)
(for details see see http://www.hirose-connectors.com/ or http://www.farnell.com/
Aeroflex Weinschel Fixed Coaxial Attenuator Model 3T/4T
(for details see http://www.aeroflex.com/ams/weinschel/pdfiles/wmod3&4T.pdf)
Audio
DSB75
PC
GSM
test equipment
GPS/GLONASS
test equipment
GSM
RS232
cable
Audio
test equipment
Votronic
handset
Power
supply
COM1
(ASC0)
Headset
If using PCM Interface
(not for approval measurements)
Power
GND
Codec-DSB75 adapter
SIM card
holder
USB
AH6-DSB75
adapter
ANT3
ANT2
ANT1
Audio
Uranus
Module
mounted on
eval board
Audio
SMA RF connector
manually soldered onto Pogo
pads
Detail:
H
i
r
o
s
e
U
.
F
L
c
a
b
l
e
GPS/
GLONASS
I
f
u
s
i
n
g
a
n
a
l
o
g
a
u
d
i
o
Module
mounted on
eval board
flexible cable
80-pin
Detail,
Module on AH6 Adapter
RF connection via
UFL on Module
RF connection via
Pogo Pad to AH6
Adapter