Safety data sheet

8. Exposure Controls / Personal Protection
Ingredients with workplace control parameters
Contains no substances with occupational exposure limit values.
Engineering measures : Processing may form hazardous compounds (see section 10).
Ensure adequate ventilation, especially in confined areas. Minimize
workplace exposure concentrations. Dust formation may be relevant in the processing of this product. In
addition to substance-specific OELs, general limitation of concentrations of particulates in the air at
workplaces have to be considered in workplace risk assessment. Relevant limits include: OSHA PEL for
Particulates Not Otherwise Regulated of 15 mg/m3- total dust, 5 mg/m3 –respirable fraction; and ACGIH
TWA for Particles (insoluble or poorly soluble) Not Otherwise Specified of 3mg/m3 –respirable particles,
10 mg/m3- inhalable particles.
Personal protective equipment
Respiratory protection : No personal respiratory protective equipment normally required.
Hand Protection
Remarks : Wash hands before breaks and at the end of the workday.
Eye protection : Wear the following personal protective equipment: Safety glasses
Skin and body protection : Skin should be washed after contact.
Hygiene measures : Ensure that eye flushing systems and safety showers are located close to the
working place. When using do not eat, drink or smoke. Wash contaminated clothing
before re-use. The precautions are for room temperature handling. Use at elevated
temperature or aerosol/spray applications may require added precautions.
9. Physical and Chemical Properties
Appearance : Grease
Color : gray
Odor : none
Odor Threshold : N/A
pH : N/A
Flash point : <200°C Method:closed cup
Evaporation rate : Not applicable
Flammability (solid, gas) : Not classified as a flammability hazard
Explosive properties : Not explosive
10. Stability and Reactivity
Reactivity : Not classified as a reactivity hazard
Chemical stability : Stable under normal conditions.
Possibility of hazardous reactions: Can react with strong oxidizing agents. When heated to temperatures
about 150°C (300°F) in the presence of air, product can form formaldehyde vapors.