User manual

5
INTRODUCTION
Panel Descriptions
1 L/R
ConnecttwoRCA-typecablesfromtheseoutputstothedisplay,audioamplier,or
receiver.Only2channelLPCMfromtheHDMIinputcanbepassedtotheseoutputs.
Multi-channelbit-streamsuchasDolbyDigitalwillnotbepassedtothisoutput.
2 Composite
ConnectanRCA-typecablefromthisoutputtotheCompositeinputonthedisplay
orA/Vreceiver.
3 S-Video
ConnectanS-VideocablebetweenthisoutputandtheS-Videoinputonthedisplay
orA/Vreceiver.
4 CoaxOut
ConnectanRCA-typecablefromthisoutputtotheS/PDIFconnectoronareceiveror
audioamplier.
5 PAL/NTSC
SwitchesbetweenNTSC(60Hz)andPAL(50Hz)output.Makesurethatyouusethe
properoutputforthetelevision.Usingthewrongformatwillresultinaunrecognizable
pictureandmaydamageyourtelevision.
6 UnderScan/OverScan
Mostanalogtelevisionsetsweredesignedtoacceptanover-scannedsignal.Ifthe
resultingvideosignaldisplaysablackborderaroundtheedges,thensetthisswitchto
OverScan.Iftheresultingvideosignalisstretchedbeyondtheedgeofthedisplay,then
setthisswitchtoUnderScan.
7 HDMIIn
ConnectanHDMIcablefromtheHi-Defsourcetothisconnector.
8 USB
Usedtoupgradethermware.Seepage10forinformationonupgradingthermware.
9 5VDC
Connecttheincluded5VDCpowersupplytothisreceptacle.
10 Power
ThisLEDwillglowbrightblueoncetheincludedpowersupplyisconnectedbetweenthe
scalerandanavailableelectricaloutlet.
