User manual

12
Once both the sending and receiving units are linked and powered, basic
confi guration can proceed. This section of the manual refers to the sending unit
as the LOCAL NODE, and the receiving unit as the REMOTE NODE.
NOTE: The following steps are for manual confi guration of the nodes for a
basic secure network. These steps are optional, as the nodes will function with
their default settings. However, for security and performance purposes, it is
recommended that the following steps be performed. Automatic confi guration is
also possible using the Automatic Security Confi guration feature on page 17 in
lieu of the procedure outlined in this section.
1. Ensure that both the local and remote nodes are powered and are properly
linked.
2. Confi rm that the computer with the installed GefenTV Ethernet Over PLC
software is connected to the local node.
3. Start the Gefen TV Confi g Tool from this location:
Start Menu \ All Programs \ GefenTV Ethernet Over Power Line \ Gefen TV Confi g Tool
4. The introduction screen should appear as the image below. Click on the next
button to continue.
5. The program will begin to search for all connected nodes.
CONFIGURING THE GEFENTV ETHERNET OVER PLC