User manual

11
1. Connect the source (i.e. computer, router, switch) to the GefenTV Ethernet
Over PLC sender unit using the supplied CAT-5e cable.
2. Connect the Ethernet devices (i.e. computer, game system, set-top box)
to the GefenTV Ethernet Over PLC receiver unit. Up to four devices are
supported.
3. Connect the included power cables to both the GefenTV Ethernet Over PLC
sending and receiving units. Please ensure that the sender and receiver
units are connected to the same power line system on the same phase.
POWER LED: Once the power cable is connected, the Power LED should
become active with a solid blue color.
LAN LED: When a valid Ethernet connection is detected on the sending and
receiving Ethernet jacks, their corresponding LED’s will become active and
should emit a solid blue color.
LINK LED: The Link LED should be fl ashing red on initial boot up. Once a link
between the sending and receiving units has been established, it will emit a solid
blue color on both units.
IMPORTANT: The Link LED must be emitting a sold blue color before
confi guration can continue. If this LED continues to fl ash red on both the sending
and receiving units, it is possible that they are not on the same phase. Please
confi rm that both the sending and receiving units are attached to the same phase
by trying the unit on another power outlet.
CONNECTING THE GEFENTV ETHERNET OVER PLC