Specifications

CHANGING THE IR CHANNEL

Setting The IR Channel on the Matrix

Use the following procedure to set the proper IR channel on the Matrix.

1 Press and hold the Out 1 button for 5 seconds to enter the IR channel

selection mode. The bank of blue LED indicators will now display the

currently selected IR channel.

2 Press the Out 1 button to cycle through each IR channel. The currently

selected IR channel will by indicated by a ﬂ ashing blue LED.

IMPORTANT: The selected IR channel must be the same as the IR channel

set on the IR Remote (see page 11). Refer to the table below for setting the

IR channel.

3 Once the proper IR channel has been selected, press and hold the Out 1

button for 5 seconds to conﬁ rm and exit IR channel selection mode. The

currently selected input source will now be indicated.

IR Channel Table

Input LED IR Channel