User manual

70
RS-232 / IP / UDP CONTROL
#hpdto Command
The#hpdtocommandcyclestheHPDlineonthespeciedinput.Thiscommandisthe
equivalentofperformingaphysicalhot-plug(disconnectingandreconnecting)onthe
sourcedevice.

Syntax:
#hpdto param1


Parameters:
param1 Input    [1...32]
Example:
#hpdto 17
HPD cycle on input 17
#lock_fo Command
The#lock_foenables/disablesthepowerlockstate.Enablingthisfeaturewillstorethe
+5Vstatusforeachinputpriortopowering-downthematrix.The+5Vstateispreserved
whenthematrixispowered.

Syntax:
#lock_fo param1


Parameters:
param1 State    [0...1]
Value Meaning
0 Disable
1 Enable
Example:
#lock_fo 1
‘+5V’ on inputs is locked