User manual

65
RS-232 / IP / UDP CONTROL
r Command
Thercommandroutesthespeciedinputtothespeciedoutputs.Onlyoneinputcan
bespeciedatatime.However,uptoeightoutputscanbespeciedatatime.Donot
precedethiscommandwiththe“#”symbol.
Syntax:
r param1 param2 ... param9


Parameters:
param1   Input    [1...32]
param2   Output    [1...32]
Notes:
Ifparam2=0,thenthespeciedinputwillberoutedtoalloutputs.Thescommandwill
performthissamefunction.Seethenextpagefordetailsonthescommand.
Examples:
r 1 2 3 7 8 9
Input 1 is routed to Outputs: 2 3 7 8 9
r 5 0
Input 5 is routed to all Outputs