User manual

56
RS-232 / IP / UDP CONTROL
#use_tcp_term_pass Command
The#use_tcp_term_passcommandenablesordisablesthelogincredentialswhen
startingaterminalsession.
Syntax:
#use_tcp_term_pass param1

Parameters:
param1 State    [0...1]
Value Meaning
0 Disable
1 Enable
Notes:
Arebootisrequiredafterusingthiscommand.
Example:
#use_tcp_term_pass 1
TCP Terminal password at login is set to ON
#use_udp_access Command
The#use_udp_accesscommandenablesordisablesUDPaccessmode.
Syntax:
#use_udp_access param1

Parameters:
param1 State    [0...1]
Value Meaning
0 Disable
1 Enable
Notes:
Arebootisrequiredafterusingthiscommand.
Example:
#use_udp_access 1
UDP Access is set to Enabled