User manual

53
RS-232 / IP / UDP CONTROL
#set_udp_rport Command
The#set_udp_rportcommandsetstheremoteUDPlisteningport.ThedefaultUDP
remoteportis50008.
Syntax:
#set_udp_rport param1

Parameters:
param1   Port    [1...65535]
Notes:
Arebootisrequiredafterusingthiscommand.
Example:
#set_udp_rport 30
New UDP Remote port set to: 30
#sgateway Command
The#sgatewaycommandsetsthenewIPgateway.Thegatewaymustbetypedusing
dot-decimalnotation.Thedefaultgatewayis192.168.1.254.
Syntax:
#sgateway param1

Parameters:
param1   Gateway
Notes:
Arebootisrequiredafterusingthiscommand.
Example:
#sgateway 192.168.1.1
New IP Gateway set to: 192.168.1.1