User manual

11
INTRODUCTION
Back Panel Descriptions
1 Out(1-32)
Connecttheoutputdevicestotheseports.Outputbanksareshownusingthe
GefenPROELR-POLExtender(GEF-DVI-8ELR-S),theGefenPROFiberOpticExtender
(GEF-DVI-1FO-S),andtheGefenDVIOutputBoard(GEF-MOD-8DVI-O).
2 Power(Input/Outputboards)
EachInputandOutputcardhasitsownpowerindicator.ThisLEDindicatorwillglow
brightbluewhenthecardisproperlyinstalledandthepowertothe32x32ModularMatrix
isapplied.
3 CoverPlate
IntheeventthatanOutput(orInput)boardisnotrequired,thecoverplatecanbeinstalled
topreventforeignparticlesorobjectsfromenteringthesystem.
4 In(1-32)
Connectthesourcedevicestoeachoftheseports.Atthetimeofthiswriting,onlyDVI
inputmodulesareavailable.
5 RS-232SerialPort
ConnectstotheRS-232controldevice.The32x32ModularMatrixmaybeswitched
remotelyusingthisport.Seepage37-74formoreinformation.
6 IP/UDP/TelnetControl
Connectthe32x32ModularMatrixtoanetworkinordertouseIP/UDP/Telnetcontrol.
7 IR
ConnectanIRextendertothisIRport.
8 Power
ThisLEDindicatorglowsbrightbluewhenthematrixispoweredon.
9 PowerSupply(1-2)
ConnecttheincludedACpowercordsfromthesereceptacletoanavailableelectrical
outlet.Theredundant(secondary)powercableshouldbeconnectedtoanelectricaloutlet
onadifferentcircuit.Eachpowersupplyis110/220VAC.
10 GroundingTerminal
Providesadischargepathtogroundincaseashortcircuitoccursbetweenthe“hot”
leadofthepowersupplyandtheenclosureoftheMatrix.Thegroundingwireshouldbe
attachedfromthegroundingterminaltoanapprovedgroundpath.

NOTE:Dependinguponthepackageoptionofthe32x32Modular
Matrixthatwaspurchased,theback-panelmaydiffer.