User manual

This manual explains the installation and operation of the Wireless USB 2.0 Extender.

The instructions in this guide assume a general knowledge of computer installation

procedures, wireless network installation requirements, and some understanding of

USB devices.

NOTE: Notes give additional information that could make installation easier.

To complete the installation, you will also require the following items that are not

included with the product:

• USB 1.1 or 2.0 compatible computer

• USB device(s)

NOTE: The Wireless USB 2.0 Extender uses an IEEE 802.11g radio platform to

wirelessly communicate between the Wireless USB 2.0 Sender unit and the Wireless

USB 2.0 Receiver unit using the 2.4GHz radio frequency range. Other products, such

as wireless routers and 2.4GHz cordless telephones, also broadcast in this same

2.4GHz range. Please be aware of potential interference issues with such products

before you begin installation of the Wireless USB 2.0 Extender.

NOTE: The Wireless USB 2.0 Sender unit and the Wireless USB 2.0 Receiver unit of

your new Wireless USB 2.0 Extender have been “Paired” during manufacturing. This

means that they will only communicate with each other, even if other Wireless USB 2.0

Extender units are installed near by.

NOTE: Use only the AC adapters supplied with the Wireless USB 2.0 Extender. Use

of substitute adapters may cause permanent damage to the system and will void the

warranty.

The Wireless USB 2.0 Extender provides the freedom to connect high performance and

high speed USB peripherals anywhere up to 100 feet from the CPU. Instant access to

data (up to 54 Mbps) with zero wires. Work with your USB 2.0 peripherals as if they

were all connected locally.

Wireless Hi-speed USB 2.0 transmits data up to 54 Mbps allowing for little or no

downtime. Compatible with original USB and uses the same cables and connectors.

READ THESE NOTES BEFORE INSTALLING OR

OPERATING THE USB 2.0 EXTENDER SYSTEM.

* The wireless USB extender does not support isochronous USB.

* In order to operate properly, the Wireless USB 2.0 Extender sender and receiver units

must not exceed 100 feet.

* To prevent interference, keep sender and receiver in plain sight of each other.

INTRODUCTION