User manual

MAINTENANCE & TROUBLESHOOTING (CONT...)
12
Symptoms/Cause Remedy
Link LED on Wireless USB 2.0 Sender unit
is on;
Host LED on Wireless USB 2.0 Sender
unit is off.
Cause:
1.
2.
3.
4.
5.
6.
7.
8.
Disconnect all USB devices from the
Wireless USB 2.0 Receiver unit.
Disconnect the Wireless USB 2.0
Sender unit from the computer.
Disconnect and then reconnect the
power adapters to the Wireless USB
2.0 Extender.
Reconnect the Wireless USB 2.0
Sender unit to the computer.
In the Universal Serial Bus controllers
section of Device Manager, check
that the Wireless USB 2.0 Extender is
recognized as a “Generic USB Hub”.
If the problem persists, move the
Wireless USB 2.0 Sender unit and
Wireless USB 2.0 Receiver unit
together so that they are about 1 meter
apart (3’) and power both units and
connect the Wireless USB 2.0 Sender
unit to the host PC.
Confi rm that the Wireless USB 2.0
Extender can establish a radio link and
that the Host LED’s turn on.
If the Wireless USB 2.0 Extender is
still not recognized, contact Technical
Support for assistance (see page 20).
The computer is not functioning.
The Wireless USB 2.0 Sender unit is
not connected to the computer.
There is too much Radio Interference
for USB communication to succeed.
The Wireless USB 2.0 Extender is
a)
b)
c)
d)