User manual

VIEWING CHANGING THE 802.11g RADIO CHANNEL (CONT...)

Once the desired 802.11g Radio Channel is displayed, press and hold the Pair/CH

button for 10 seconds. The button can be released when the Host, Link and Activity

LED’s start to blink rapidly.

NOTE: If the LED’s do not start blinking rapidly within 20 seconds release the button

and conﬁ rm that the LED pattern still shows your desired channel pattern. If it does,

repeat step 5. If it does not, return to step 4.

Upon release of the Pair/CH button the LED’s will continue to blink for approximately

20 seconds while the Channel Change is stored and the 802.11g radio reboots.

Once the blinking stops the Channel Change is complete.

NOTE: DO NOT remove power while LED’s are blinking.

NOTE: If the channel selection on the Wireless USB 2.0 Sender unit and the

Wireless USB 2.0 Receiver unit are no longer the same the USB trafﬁ c will now stop.

If the channel selection on the Wireless USB 2.0 Sender and Wireless USB 2.0

Receiver are made the same the USB trafﬁ c will begin.

If only one side of the system has been changed repeat steps 1 to 6 for the other

side of the system. If channel selection is complete on both sides of the system go

to step 8.

Connect a USB cable between the Wireless USB 2.0 Extender and the host PC,

and conﬁ rm its operation by checking if it is listed in Device Manager (for Windows

installations), or System Proﬁ ler (for Mac OS X installations) under Universal Serial

Bus controllers as a “Generic USB Hub”.