User manual

The Wireless USB 2.0 Extender can operate on one of three 802.11g radio channels.
Each radio channel broadcasts data in a different frequency band within the 2.4GHz
range. The Wireless USB 2.0 Extender can be confi gured to operate on channels: 1, 6,
and 11.
By selecting a different Radio Channel, you can try to fi nd a channel with minimal radio
interference. This can improve signal quality and data rates.
NOTE: When changing the Radio Channel for a “Paired” system, the channel change
MUST BE completed on BOTH the Wireless USB 2.0 Sender unit and the Wireless
USB 2.0 Receiver unit. The order is non-specifi c.
NOTE: Stop all devices connected to the Wireless USB 2.0 Receiver unit prior to
changing the channel on either unit. Changing the Radio Channel will disrupt USB
traffi c.
VIEWING CHANGING THE 802.11g RADIO CHANNEL (CONT...)
7
1.
2.
3.
Power on either the Wireless USB 2.0 Sender unit or the Wireless USB 2.0 Receiver
unit and wait for approximately 20 seconds before proceeding to step 2. If the unit is
already on, proceed to step 2.
On the selected Wireless USB 2.0 Sender unit or Wireless USB 2.0 Receiver unit,
press and hold (do not release) the Pair/CH button for a minimum of 10 seconds.
The button can be released when the Host, Link and Activity LED’s start to blink
rapidly.
Upon release of the Pair/CH button the current 802.11g Radio Channel will be
displayed by as a pattern on the Host, Link, and Activity LED’s. Please see the fi gure
below for the description of the LED Radio Channel patterns.
4.
To change the channel press and release the Pair/CH button until the desired
channel pattern as seen in the above fi gure is visible on the LED’s. Upon reaching
channel 11 the pattern will return to channel 1.
NOTE: If the Pair/CH button is not pressed for 60 seconds the LED’s will return to
their normal operation and no changes will be made to the current channel selection.
NOTE: If wireless communication is present it will continue until a channel change is
confi rmed.