User manual

page | 6
Installation
Connection Instructions
► Video
1. Connect the included HDMI cable between the Ultra Hi-Def source and the HDMI In
port on the Sender unit.
2. Connect an Ultra HD display to the HDMI Out port on the Receiver unit using another
HDMI cable.
► CAT-5 / Ethernet
3. Connect a CAT-5e (or better) cable, up to 495 feet (150 meters) from the Link port on
the Sender unit and the Link port on the Receiver unit.
4. Connect an Ethernet cable from the Ethernet port on the Sender unit to the network.
5. Connect an Ethernet cable from the Ethernet port on the Receiver unit to the network.
► IR
6. Refer to Bidirectional IR Control (page 11) for details on connecting IR devices.
► RS-232
7. Connect the included 3-pin Phoenix-to-DB-9 (female) cable between the RS-232
controller and the Sender unit.
8. Connect the included 3-pin Phoenix-to-DB-9 (male) cable between the RS-232 device
and the Receiver unit.
► Power
9. Connect the included 24V DC power supply to the power receptacle on either the
Sender or Receiver unit. It is recommended that the power supply be connected to
the Sender unit.
10. Connect the opposite end of the power supply to an available electrical outlet.
Information
Resolution will affect extension distance. 1080p Full HD can be extended up
to 495 feet (150 meters) and is limited to 8-bit color depth. 4K resolutions can
be extended up to 330 feet (100 feet). Refer to HDBT (HDBaseT™) Mode
(page 17) for details.
Getting Started Getting Started