User manual

12
RMT-8HDS-IR INSTALLATION
1. Remove battery cover from the back of the RMT-8HDS-IR remote.
2. Verify that DIP switches 1 and 2 are in the down (OFF) position.
3. Insert the battery, hold the battery so that you can see the positive side
facing up (the side with the buttons must be facing down).
4. Test the RMT-8HDS-IR remote by pressing ONLY one button at a time. The
indicator light on the remote will fl ash once each time you press a button.
WARNING: Do not press multiple buttons simultaneously and do NOT press
buttons rapidly. These actions will cause the remote to reset and steps 1-4
will have to be repeated.
Note: The RMT-8HDS-IR ships with two batteries. One battery is required for
operation, the second battery is complimentary.
The following are the DIP switch combinations that correspond to the Remote
Code menu option on the HDSDI to DVI Plus Scaler (Please see Menu Functions
section on page 8 for more information).
1
2
Remote Channel 0:
1
2
Remote Channel 1:
1
2
Remote Channel 2:
1
2
Remote Channel 3: