User manual

RMT2-IR INSTALLATION

1. Remove battery cover from the back of the RMT2-IR remote.

2. Verify that dip switches 1 & 2 are in the down (OFF) position.

3. Insert the battery, hold the battery so that you can see the positive side facing

up. The side that is not marked must be facing down.

4. Test the RMT2-IR remote by pressing ONLY one button at a time. The indicator

light on the remote will ﬂ ash once each time you press a button. WARNING:

Do not press multiple buttons simultaneously and do NOT press buttons rap-

idly. These actions will cause the remote to reset and steps 1-4 will have to be

repeated.

Note: The RMT2-IR ships with two batteries. One battery is required for opera-

tion, the second battery is complimentary.

Optional RMT-2 wired remote

(connection shown on page 3)

RMT2-IR

Infrared Remote

RMT-EXTIR

Infrared Signal

Extender