Datasheet

OPERATION NOTES
On power up, the DVI to HD-SDI Pro will automatically detect the format of the input
signal. The unit is controlled using the included remote or through the RS-232 port.
The following are the buttons for the RMT-8HDS-IR Remote Control Unit (included):
- UP (Navigates cursor up)
- LEFT (Navigates cursor left)
- Enter (Accept Operation / Return to Menu)
- RIGHT (Navigates cursor right)
- DOWN (Navigates cursor down)
- MENU (Show / Hide On screen Display)
- OUTPUT (Change Output Format)
- SOURCE (Non operational)
To bring up the on screen menu for the master device, press the MENU button once.
To bring up the menu for the slave device, press the MENU button again. Pressing
the MENU button once more will exit the menu system. Navigation is done using
Buttons up, left, right, and down; Push the Enter button to accept the cursor focus.
Pressing the Output button cycles through the following output modes:
480i - 576i - 720p - 1080i
Other functions and output modes can be accessed through the on screen menu.
To Restore I/O settings, simply recycle power on the Scaler
*Note: The IR Remote Control Unit has a small bank of adjustment switches known
as DIP (Dual Inline Package) switches located inside the battery compartment. Both
DIP switches under the remote battery cover must initially be in the OFF position
to communicate with the Scaler, as they control the IR frequency used. Please see
page 7 for more information on how to set the DIP switches.
2
RMT-8HDS-IR
Remote Control
Unit
DIP
switches
Front
Back